AJK Offroad Small Panel Tab, 10 Gauge, 1/4 or 3/8 Hole

The AJK Offroad small panel tab attaches body panels to your SXS, UTV, truck, Jeep or any off-road vehicle.

It is CNC laser cut from 10-gauge, 0.130-inch P&O steel with a 1/4 or 3/8-inch hole and sold individually. AJK Offroad CNC laser cuts its tabs for clean, consistent edges, so every tab matches and welds in place easily. Weld it to your roll cage, bumper or frame wherever you need a solid mounting point for panels, lights, lines or brackets.

Key Features

• Body panel mounting
• 0.130-inch P&O steel
• 1/4 or 3/8-inch hole
• CNC laser cut
• Sold individually
• Made in USA

Built To Solve: Making Your Own Mounting Tabs

• Cutting tabs by hand
• Inconsistent, rough-edged brackets
• No clean way to bolt parts to the cage

Best For: Fabricators and DIY Off-Road Builders

• Roll cage and bumper builders
• Body panel and roof installs
• Shock, light and accessory mounts

Specifications

• Material: 10-gauge, 0.130-inch P&O steel
• Holes: 0.25 or 0.375 inch
• Quantity: sold individually
• Made in USA
• Manufacturer Part Number: 200272 / 200497

Fitment

Universal fabrication part; check the material thickness, hole size and tubing size listed before ordering.

FAQ

What is the AJK small panel tab for?

Attaching body panels.

How thick is it?

0.130 inch (10 gauge).

What hole sizes are offered?

1/4 or 3/8 inch.

Is it sold individually?

Yes.

Is there a 10 pack?

AJK sells body panel tabs in 10 packs.

Is it made in the USA?

Yes, per AJK Offroad.

Why AJK Offroad

AJK Offroad CNC laser cuts and machines its fabrication tabs, gussets, plates, washers and recovery mounts in the USA from steel and billet aluminum. Builders use them on roll cages, bumpers, body panels, shock and link mounts and recovery points for side-by-sides, UTVs, tube buggies, rock bouncers and Jeeps, and Dunes 2 Dezert SXS carries the full AJK Offroad fabrication range in one place.

Build It Right

Order what you need, then add AJK Offroad gussets and weld washers below.