AJK Offroad Polaris Pro R / Turbo R Radius Rod Plate

The AJK Offroad Polaris Pro R / Turbo R Radius Rod Plate is a 7-gauge CNC laser cut steel plate that bolts to the factory radius rod and rear bumper mount positions on the Pro R and Turbo R using factory hardware. No drilling, no welding required for the plate installation itself. A popular foundational component for aftermarket rear bumper builds, recovery point mounts, and rear accessory installations on the Pro R and Turbo R platform. Made in the USA by AJK Offroad.

Key Features & Benefits

• 7-Gauge CNC Laser Cut Steel — Heavier gauge than the standard RZR plate — appropriate for the higher-stress rear mounting locations on the Pro R and Turbo R
• Uses Factory Hardware — Bolt-on installation to existing Pro R / Turbo R factory rear frame hardware positions
• Rear Bumper Mount Foundation — The go-to plate for builders mounting custom rear bumpers and accessories to the Pro R and Turbo R rear frame
• No Welding for Plate Install — Plate installation is bolt-on — welding is only needed if building a custom tube bumper to the plate
• Made in USA — CNC laser cut by AJK Offroad

Specs & Fitment

Vehicle Fitment — Polaris:

• RZR Pro R / Pro R 4 (all years)
• RZR Turbo R (all years)

Frequently Asked Questions

Why is this 7-gauge instead of the 1/4" used on the standard RZR plate?

7-gauge (.1793") is thicker than standard 1/4" (.250") plate — appropriate for the higher loads and stresses at the Pro R and Turbo R rear frame mount positions. AJK specs the correct gauge for each platform based on the intended use and load requirements.

Is this the same as the Billet Radius Rod Pull Plate?

No — the Billet Radius Rod Pull Plate is a CNC machined billet aluminum plate designed as a visual and functional upgrade at the radius rod location. This steel plate is the structural mounting base for rear bumpers and recovery accessories. Both are available separately on the site.

Is any hardware included?

The plate uses existing factory hardware. No additional fasteners are needed.

Will this fit the Pro XP?

No — this plate is designed for the Pro R and Turbo R rear frame geometry. The standard RZR radius rod plate listed separately is for the XP 1000 and Turbo platforms.

Can I attach a tow hitch to this plate?

This plate is designed as a bumper mount foundation. For a dedicated receiver hitch, the AJK RZR XP Turbo Rear Receiver Hitch is available separately on the site.

Build a solid rear bumper mount on your Polaris Pro R or Turbo R with the AJK Offroad Radius Rod Plate — available now at Dunes 2 Dezert SXS, your Desert Southwest source for Polaris RZR Pro R fabrication hardware and AJK Offroad rear bumper components.